Communication between mobile devices and flight control boards can
be achieved through Bluetooth you can use mobile devices to set the
parameters of the flight controller.APP currently only supports
Bluetooth Low Energy Module. Not only for SpeedyBee Bluetooth
Module we can also try to connect with other Bluetooth Low Energy
devices like HC-08 HM-10 etc but if using the Speedy Bee
Bluetooth-UART Adapter this Bluetooth module will deactivate and
activate automatically according to the status of the
drone(armed/disarmed) no Bluetooth signal interference during the
flight.
Flight Controller Requirements:
Betaflight firmware version ≥ 3.2.0
iNav FC version ≥ 2.0.0
Butterflight firmware version ≥ 3.1.0
System Requirements : Android 4.4 +
Instructions for use:
1.Connect the Bluetooth PCB with the UART interface of the Flight Controller or use the flight controller integrated Bluetooth.
2.Open the Betaflight Configurator on the Ports tab open the Configuration/MSP port of the Bluetooth PCB for the Bluettooth module of BLE4.0 19200 is the recommended baud rate value.
3.Open the APP connect the Flight Controller via Bluetooth and you can adjust the parameters now.
Notes:
1.Currently Betaflight/Butterflight/iNav configurator supported.
2.support BLE(Bluetooth Low Energy)/OTG-USB.
Flight Controller Requirements:
Betaflight firmware version ≥ 3.2.0
iNav FC version ≥ 2.0.0
Butterflight firmware version ≥ 3.1.0
System Requirements : Android 4.4 +
Instructions for use:
1.Connect the Bluetooth PCB with the UART interface of the Flight Controller or use the flight controller integrated Bluetooth.
2.Open the Betaflight Configurator on the Ports tab open the Configuration/MSP port of the Bluetooth PCB for the Bluettooth module of BLE4.0 19200 is the recommended baud rate value.
3.Open the APP connect the Flight Controller via Bluetooth and you can adjust the parameters now.
Notes:
1.Currently Betaflight/Butterflight/iNav configurator supported.
2.support BLE(Bluetooth Low Energy)/OTG-USB.
Show More >